Posted by Paul Frankel (66.66.155.179) on August 27, 2009 at 19:42:09:
I need some advice on the proper method of flywheel removal on this motor. there are 3 small holes in the flywheel that are reminiscent of bolt holes for a 3 lobe puller but they do not appear to be threaded. ? I tried the pry and whack technique with no success. There is only a few thousandths end play in the crank, and I don't think it's enough to loosen the taper when struck.
This machine did run and did a good job too. I need to get underneath the wheel to see where my spark went.
Any ideas?
Thanks Paul F.